Roomba j Series and Combo 10 Max
Roomba j Series and Combo 10 Max Error 1: Left wheel hanging or stuck
Quick answer
Error one (1) means your Roomba j Series or Combo 10 Max robot is on an obstacle or an uneven surface and the left wheel is stuck.
Editor: Feroz Sheikh · Updated · How we verify
Exact message and stated cause
Check your model first
These instructions cover Roomba j Series and Combo 10 Max (Roomba Combo 10 Max, Roomba j5, Roomba j7, Roomba j7+, Roomba j9+ in this catalog). Match the full model name and the complete message before continuing.
Manufacturer checks in order
- Lift Roomba off the floor, place it in the center of the room and restart the clean cycle.
- If this error occurred on a flat surface, check the left wheel for obstructions.
- Push the wheels up and down several times and shake out any loose debris that may be trapped in the wheel well.
- Briskly turn both wheels by hand and make sure they turn freely and that each wheel exhibits the same amount of resistance.
Safety notes
Use the instructions for your exact robot and dock. Stop if the unit is wet, unusually hot, damaged or has a swollen battery. Contact the manufacturer; do not bypass sensors or open sealed electrical assemblies.
When to contact support
If you believe you're in warranty, please contact iRobot Customer Care.
Part usually involved
Only if the checks above fail. The manufacturer article, not this site, decides whether a part is needed.
Wheel module
VacPartFit has no sourced wheel module page for these models yet. Use the manufacturer's own ordering route and match the exact model first.
Before buying a part
No. An error code does not prove a part has failed or that a seller's replacement fits. Check the exact manufacturer identifier separately.
Questions about this error
Which models does this guide cover?
These instructions cover Roomba j Series and Combo 10 Max (Roomba Combo 10 Max, Roomba j5, Roomba j7, Roomba j7+, Roomba j9+ in this catalog). Match the full model name and the complete message before continuing.
Does this error prove I need to buy a replacement part?
No. An error code does not prove a part has failed or that a seller's replacement fits. Check the exact manufacturer identifier separately.
Official sources
This guide summarizes published manufacturer instructions. It does not claim a hands-on repair or physical fit test.