Dreame · original L10s Ultra manual
Dreame L10s Ultra troubleshooting: L10s Ultra did not resume after charging
Editor: Feroz Sheikh · Updated · How we verify
Do Not Disturb or manually returning the robot affects resumption.
Manufacturer source checked 2026-10-01. Match the entire message and exact model family before following a fix.
What this message means
Do Not Disturb or manually returning the robot affects resumption. This applies to the original L10s Ultra rather than every Gen 2, Pro Ultra or newer station. Similar Ultra names do not establish identical tank, button or pump procedures. Record whether the symptom concerns the robot or the station before retrying.
Checks in order
- Check job history and the Do Not Disturb window.
- Check for manual docking and use the appropriate new job if needed.
How to decide whether the check worked
Run one short supervised retry after the permitted checks. Compare the exact warning with the original message. A different warning needs its own instructions. If the robot completes the attempt, observe the next normal job; one successful retry does not prove that damaged hardware has been repaired.
Write down whether the same message returns immediately, only during cleaning, or only while docking. Keep the robot model and software version with that observation. A short recording of the visible message can help manufacturer support distinguish a repeated fault from another warning; keep serial numbers and personal information out of anything shared publicly.
Does this require a replacement part?
Inspect the named user-serviceable component before ordering. Cleaning, normal seating and a clear route can resolve symptoms without a purchase. If damage is visible, match the full model and manufacturer identifier to the replacement record. This warning alone cannot identify a compatible seller product.
Use the part links below to check the original identifier, exact model, source market and written fit caveat. The error message itself does not confirm that a seller's replacement fits. An unverified or excluded relationship has no shopping button. If the part is a battery, charging component or sealed motor, use the manufacturer service route rather than adapting a similar assembly.
When to contact support
Contact the manufacturer if this exact warning returns after the listed checks or a component will not seat normally. Provide the model, complete message, when it occurs and the checks already performed. Let support decide whether a service assembly is required.
Stop the test if the robot is wet, unusually hot, smells abnormal, has a damaged cord or shows battery swelling. Do not disable cliff sensors, force a jammed mechanism or open a sealed electrical assembly to make the message disappear. Use a physical barrier around drops during any supervised retry.
Manufacturer evidence and related messages
Read the official Dreame support article or manual. This page provides an editorial troubleshooting explanation; it does not claim a physical repair test.